What you need
- wood trim of your choice (I used 1×2 primed MDF)
- Measuring tape
- Painters tape
- ScotchBLUE Pre-taped Painter’s Plastic and cutter
- nail gun and 2 inch nails
- sprayer and paint
- Caulk and caulk gun
- Wood filler
- Primer, small roller and foam brush
Let’s get building
- Map out your design on the wall using painters tape. Yes, this is a tedious task, but it will set the basis for the entire project.
- Measure the length of each edge of the square.
- Using the miter function, cut each piece of wood. Only cut a few pieces of wood and nail them because some measurements may be off. Be sure to label each piece of wood A, B, C, to correspond with your diagram. Otherwise, you can get mixed up with which piece fits in which space.
- When you begin nailing the wood trim, nail to adjacent pieces already on the wall. Do not nail any floating pieces that do not touch another piece of trim
- Once the design is complete, fill all the miter edges with wood filler. I recommend using your fingers as you can control the filler better
- After the wood filler is dry, sand down the edges. I used an electric sanding machine. Clean all the dust from sanding
- Caulk all edges where the wood trim meets the wall. Use a small bead of caulk, and be sure to wipe off excess with a wet finger
- Re-prime the MDF. This isn’t a must do, but the paint will go on much more evenly if you do 2 coats of primer. Honestly, I worked so hard on the wood trim design that I didn’t want to take any shortcuts on the finishing touches.
- Tape your wall. If you opt to use a sprayer, spend the extra $5 and purchase the ScotchBlue Painters tape with the plastic attached. It’s 4 feet of plastic attached the painters tape and it sticks to your furniture and tiles to protect them. It’s amazing!
- Paint your wall. I used a sprayer, but I had to use a roller and brush beside the toilet and vanity. A sprayer is better for open walls with no obstructions in front of them. Next time, I would probably paint the wall first and give it a final coat with the sprayer for an even finish.
- Proudly show off your new wall and be sure to tag me so I can admire it!
I LOVE this wall. This was my first time doing a board and batten wall. Although I picked a high traffic area (the powder room), it was a small wall. I’m glad I started with a small space as I learned a lot for my next board and batten wall.